Prices incl. VAT plus shipping costs
Ready to ship today,
Delivery time appr. 1-3 Days
- Order number: 20175
Product information “SMS COM SPC 8 and 16 Amp.”
Description
SMS COM SPC 8 and 16 Amp Climate Controller
After unpacking, check the SPC for transport damage, voltage and frequency. Never install the SPC near water pipes, rain, drains, etc. and make sure that the power is disconnected. Make sure that the workplace is clean and dry! The installation of the SPC and the rectification of defects must be carried out by a qualified electrician in accordance with the applicable standards.
Starting up
Set the switch to the “AUTO” position: The SPC works fully automatically. The fans are controlled depending on the setting. After the SPC is switched on, the connected fans always start up at full voltage for a few seconds.
Set the switch to the “0” position: The SPC is switched off in this position.
Set the switch to the “100%” position: If the automatic control no longer works due to a fault
the connected fans must be switched to this position.
Switch to this position. They are then operated at full mains voltage.
Instructions for use:
* Set the minimum ventilation level (e.g. 20%).
* Set the maximum ventilation level (e.g. 80%).
Set the ventilation bandwidth. The control range between minimum and maximum ventilation remains at least 10% (e.g. 2°C) regardless of the settings.
Set the desired temperature. If the internal temperature rises above the set
target temperature, the SPS selects the appropriate ventilation level based on the set bandwidth.
Key features
Precise climate control!
Can be connected and operated by anyone!
Adjustable minimum and maximum speed
Plug & Play: ready to use immediately!
Includes 5 meter temperature sensor
Attention!
The SMSCOM SPCs are tuned for the most common fans. However, it is possible to reset the minimum speed. Therefore, the “cal. Min” potentiometer (to the left of the fuse holder). Left is minus and right is plus. Set so that the extractor always runs in the minimum extraction position. SETTING A LOWER RESTS INCREASES THE RISK OF HUMMING. If the PLC is turned off (0 position) and then turned back on, first set the switch to 100% and only then to the auto position. This is recommended to protect connected extractors.